Installation Instructions - JVL MAC050 User Manual

6.6
6.6.1 Mounting a gear or a brake at the motor
When a gear or a brake is to be mounted on the front end of a motor it is very important
that this is done in the right way since a wrong way of mounting may have fatal influence
at lifetime of the motor or gear/brake and performance.
Please follow this instruction step by step to make sure that the mounting is done with a
good result.
1
2
378

Installation instructions

Step 1 - Make sure that the shaft collar is oriented correctly in order to
assure that the right tension around the motor shaft is possible.
Hint: Tighten the shaft collar gently just to keep it in the right position.
!
The inner and outer slit
is NOT aligned. Make sure
they are aligned as shown
at right illustration
Step 2 - Mount the gear or brake at the motor but make sure to fasten the
4 shaft bolt first before fastening the shaft collar.
Its recommended to use Locktite 278 in the threats to make sure that the
bolts stay in place.
!
Do NOT tighten the shaft collar
before the flange bolts are tightend
JVL A/S - User Manual - Integrated Servo Motors MAC050 - 4500
The inner and outer slit
is aligned as they should.
Flange bolts properly mounted
and tightend.
TT1536-01GB