JVL MAC050 User Manual page 162

5.3 Expansion module MAC00-B41
5.3.5 General power supply description
The MAC00-B41 module can be used in the MAC400 to MAC4500 motor.
Notice that only MAC800 motors with serial numbers higher than 85000 support the
B41 module. The diagram below shows how to connect power to a MAC400 motor
mounted with a MAC00-B41.
If the motor is a MAC400 up to MAC4500 then please notice that the supply voltage con-
nected to P+ and/or CVI must stay in the range +18-32VDC.
Precautions must therefore be taken if the system also contains MAC50, 95, 140 or 141
which may require 48VDC in order to reach maximum motor speed.
See also the general power supply description
158
Power supply connections to a MAC140 and a MAC400
mounted with a MAC00-B1, B2 or B4 and B41 modules.
Make sure that all
involved units are
connected to the same
potential
MAC50-141 Motor
with MAC00-B1,
B2 or B4
Power
Supply
Control voltage
Only MAC50-141 with
B2 or B4 (Optional)
MAC400 Motor
with MAC00-B41
Power
Supply
Control Volt.
Main supply
JVL A/S - User Manual - Integrated Servo Motors MAC050 - 4500
Power Supply, page
Power supply
P+
P-
O+
P+
Max. 32VDC !
P-
CVI
Mains 115 or 230VAC
Only MAC400 to 4500
89.
It is recommended
that a separate supply
line is used for each motor.
TT1137GB