JVL MAC050 User Manual page 58

2.10
2.10.9 Transferring and saving the filter
After setting the filter choices, the filter can be transferred to the motor.
The complete setup including the filter configuration can also be saved to and later re-
called from file by using the Open and Save buttons in the toolbar.
2.10.10 Additional adjustment
Now the desired filter is set up in the motor and the performance can be tested. Further
improvement may be required and typically it may be necessary to experiment in order
to obtain an optimum result.
Please note that the LOAD parameter must still be used to adjust the inertia ratio be-
tween the motor and load. See also
54
Servo filter adjustment
JVL A/S - User Manual - Integrated Servo Motors MAC050 - 4500
Adjusting the LOAD parameter, page 49.