Accessories - JVL MAC050 User Manual

6.14
The following accessories are available for the MAC motor series.
6.14.1 Cables
RS232-9-1
Setup and communication cable. Length 3 m
Standard RS232 cable that is used for connecting MAC motors with an integrated expan-
sion module to a standard computer serial COM port.
The following expansion modules include an RS232 COM port based on a 9-pole DSUB
connector which matches the RS232-9-1:
MAC00-B1
MAC00-R1
RS232-9-1-MAC
Setup and communication cable. Length 3 m.
Setup and communication cable used for the BASIC MAC motor which is NOT equipped
with a full RS232 interface. The cable can be used between the BASIC MAC motor and
a standard RS232 COM port.
WG0302 (2m) or WG0320 (20m)
Power cable with 2 x 0.75mm² inner wires + screen. The colour is black.
The cable is fitted with a Molex connector at one end. The other end is open.
This cable can be used together with the following units.
MAC50 to 141
MAC00-CS
MAC00-R3
Optional: If the Molex connector is cut off, the cables can also be used for:
MAC00-B2
MAC00-FP2
WG0402 (2m) or WG0420 (20m)
I/O cable with 12 twisted pairs (24 wires)+ screen. The colour is black. The cable is fit-
ted at one end with - 1 pcs. 6-pole connector, 1 pcs. 8-pole connector and 1 pcs. 10-pole
connector. The other end is open.
The cable can be used with following units.
MAC00-FP2
MAC00-R3
WG0502 (2m) or WG0520 (20m)
I/O cable for the basic MAC motors. The cable has 4 twisted pairs (8 wires)+ screen.
The colour is black. The cable is fitted with an AMP connector at one end which fits the
8-pole I/O connector inside the basic MAC motor. The other end is open.
The cable can be used with following units.
MAC50 to 141
MAC00-CS
448

Accessories

Fits directly to the 2-pole power connector inside the basic MAC mo-
tor.
Passes through the -CS module and connects to the basic MAC motor.
Passes through the -R3 module and connects to the basic MAC motor.
Connects to the 3-pole screw terminal named "power".
Connects to the 2-pole screw terminal named "power".
Connects inside to all the I/O's +RS232 interface. Only the power and
ProfiBus connections are not covered by this cable.
Connects inside to all the I/O's +RS232/RS485 interface.
Fits directly to the 8-pole I/O connector inside the basic MAC motor.
Passes through the -CS module and connects to the basic MAC motor.
JVL A/S - User Manual - Integrated Servo Motors MAC050 - 4500