JVL MAC050 User Manual page 351

5.11 Expansion Module MAC00-R1/R3/R4
5.11.42 Connecting the RS232 interface of the MAC00-R3 module
The illustration below shows how to connect the MAC00-R3 directly to a PC COM port.
The drawing is based on standard cables from JVL, types WG0402, WG0410 or
WG0420. See also
Please remember to connect the TX and TX-PD wires from the MAC00-R3 together to
achieve stable operation.
If the MAC motor is connected to the same RS232 line as other motors, the terminal TX-
PD should only be connected on one of the motors.
If one of JVL's standard RS232 cables (RS232-9-1 or -n) is used between the DSUB con-
nector shown and the PC com port, the RX and TX pins must be swapped since they
cross in these standard cables.
PC RS232
COM port
GND
5
Tx
3
2
Rx
1
Connector:
Cable = Female 9pin DSUB
At PC = Male 9pin DSUB
If JVL's standard programming
cable type RS232-9-1 or
used between the shown
connector and the PC the RX
and TX signal must be swapped.
Tx to pin 2 and Rx to pin 3.
JVL A/S - User Manual - Integrated Servo Motors MAC050 - 4500
Accessories, page 448
How to connect the RS232 interface of the MAC00-R3
S c r e e n t e r m in a t e d
t o t h e G N D t e r m in a l
S c re e n
If the RS232 lines are extended
through another cable this cable
must also be screened
Remember to connect TX-PD (Red)
to TX (Green) in order to achieve
-n is stable communication
for a complete list of cables and connectors.
JVL cable WG04xx
standard I/O
cable (24 wire)
Blue
Yellow
S c re e n
Green
Red
Screen must be
connected to
main ground
at rear cover.
Interface connector
MAC00-R3 internal
connector board
TT0967GB
347