JVL MAC050 User Manual page 285

5.8 Expansion Module MAC00-FP2/FP4
5.8.11 Assembly instructions for profi cables
Remove the insulation from the cable, as shown in the ac-
companying picture.
Fit the plastic part of the gland on the cable, and fold the
screen around it. Remember to first feed the cable
through the nut.
Feed the cables through the cable glands in the rear plate
of the module and tighten the nuts.
Screw the wires into the module. The red wire must go
into the B+terminal, and the green must go into the A-
terminal.
The input and output terminals can be swapped if re-
quired. The is no difference between input and output on
the board which means that it is purely hard-wired.
Attach the circuit board to the rear plate with the two
screws. REMEMBER to use the spring washers included.
The table below shows the difference between Siemens
naming conventions and the naming on the MAC00-FPx.
MAC00-FPx
name
B+
A-
JVL A/S - User Manual - Integrated Servo Motors MAC050 - 4500
Siemens Standard
name wire colour
B Red
A Green
16
36
4
All values in millimetres
IMPORTANT:
use spring washer
281