JVL MAC050 User Manual page 180

5.4 Expansion module MAC00-B42
(Continued from previous page)
"IO1" - Basic I/O's. M12 - 8-pin male connector.
Signal name
IN1
IN2
IN3
IN4
O1
O2
O+
IO-
"IO2" - Extended I/Os. M12 - 8-pin female connector.
Signal name
IN5
IN6
IN7
IN8
O3
O4
AIN1
GND
Cable Screen
Some standard cables with M12 connectors offer a screen around the cable. This screen on some cables
is fitted to the outer metal at the M12 connector. When fitted to the MAC00-B42 module, this means that the
screen will have contact with the complete motor housing and thereby also the power ground (main ground).
Isolation groups
The MAC00-B42 offers optical isolation at the digital inputs and outputs (IN1-8 and O1-4). The table above
shows a number for each pin. This number refers to the isolation group to which the terminal is connected.
Isolation group 1 means that the terminal refers to the main ground.
Isolation group 2 means that the terminal refers to the I/O ground (IO-).
5.4.6 Dip switch for RS485 active termination
Main fuse 10Amp.
Replace only with: Schurter
type "3402.0040.11" or
Littlefuse type "451-10A"
RS485 dipswitch
Both swithes «ON»
= termination enabled
Both swithces «OFF»
= termination disabled (default)
If the MAC motor is connected to other units at a RS485 line the last unit in each end of
the line must have the termination dip switches activated.
176
Description
Digital input 1
Digital input 2
Digital input 3
Digital input 4
Digital output 1 - PNP output
Digital output 2 - PNP output
Output supply +12-32VDC. Used for O1-4.
Not used/necessary for using IN1-8
I/O ground. Used for IN1-8 and O1-4.
Description
Digital input 5
Digital input 6
Digital input 7
Digital input 8
Digital output 3 - PNP output
Digital output 4 - PNP output
Analogue input +/-10V
(also used for Homing sensor).
Ground for AIN. This ground is shared with
the main ground
MAC00-B42 seen from rear side
JVL A/S - User Manual - Integrated Servo Motors MAC050 - 4500
Only MAC400 to 3000
JVL Cable
WI1000-M12
Pin no. F8T05N
1 White
2 Brown
3 Green
4 Yellow
5 Grey
6 Pink
7 Blue
8 Red
JVL Cable
WI1000-M12
Pin no. M8T05N
1 White
2 Brown
3 Green
4 Yellow
5 Grey
6 Pink
7 Blue
8 Red
Interconnect to motor
Contains all internal signals
between module and motor.
TT1281-01GB
Isolation
group
2
2
2
2
2
2
2
2
Isolation
group
2
2
2
2
2
2
1
1