JVL MAC050 User Manual page 430

6.12
Reg. Firmware / MacTalk
Nr. MacRegIo Name Name
40 V_HOME
(not
present)
41 T_HOME
(not
present)
42 HOME_MODE
(not
present)
43 P_REG_P
(not
present)
44 V_REG_P
(not
present)
45 A_REG_P
(not
present)
46 T_REG_P
(not
present)
47 L_REG_P
(not
present)
48 Z_REG_P
(not
present)
426
Registers
Size /
Access
Na / Word /
-138 RW
Na / Word /
341 RW
Na / Word /
0 RW
0-8 / Word /
0 RW
0-8 / Word /
0 RW
0-4 / Word /
0 RW
0-4 / Word /
0 RW
0-4 / Word /
0 RW
0-4 / Word /
0 RW
JVL A/S - User Manual - Integrated Servo Motors MAC050 - 4500
Description
- Velocity to use during a zero search operation (Homing operation). After the
operation has completed, the drive will go back to using the regular
V_SOLL.
-
- Defines if the motor should start a zero search immediately after start up, as
well as the type of zero search to perform when a FastMac command is
received.
Bits 7..0 define the zero search mode the motor should start up in. If this
value is zero, the motor will not perform a zero search at startup, but will
start up in the mode selected by Reg37, START_MODE. See bits 15..8
below for an exception!
The mode values are identical to Register 2, MODE_REG.
Bits 15..8 define what mode the motor will set when it receives a FastMac
command (96+16). NOTE that if all these bits are non-zero the motor will
start up in passive mode instead of starting in START_MODE!
The mode values are identical to Register 2, MODE_REG.
Bit 16 is set after a zero search has completed, and can thus be used to test
if the motor has performed a zero search at least once after +24V was last
turned on.
After a zero search has completed, the motor will always change into the
mode defined by Reg37, START_MODE (unless an error occurs that will
stop the motor and set ERR_STAT bit(s)).
- When set to 1..8, copies one of POS0..POS7 to P_SOLL, then resets to 0
- When set to 1..8, copies one of VEL0..VEL7 to V_SOLL, then resets to 0
- When set to 1..4, copies one of ACC0..ACC3 to A_SOLL, then resets to 0
- When set to 1..4, copies one of TQ0..TQ3 to T_SOLL, then resets to 0
- When set to 1..4, copies one of LOAD0..LOAD3 to KVOUT then resets to 0
- When set to 1..4, copies one of ZERO0..ZERO3 to INPOSWIN, then resets
to 0
Only MAC400 to 4500
T1508-02GB