Right Flange Shaft, Removing And Installing - Audi Q5 2008 Repair Manual

– Always clean the left flange shaft and the torque converter bell
housing in the area where the differential is accessed
-arrow A- and the shaft seal -arrow B-.
Note
Replace the shaft seal between the differential and transmission
housing -arrow B- if it is damaged. Refer to
⇒ "1.1 Overview - Final Drive", page 146
– Fill the space between the sealing and dust lip halfway with
Sealing Grease - G 052 128 A1- .
– Install the torque converter. Refer to ⇒ Servicing - 8-Speed
Automatic Transmission; Rep. Gr. 32 ; Torque Converter;
Torque Converter, Removing and Installing .
– Install the left flange shaft -1- into the transmission in direction
of -arrow B-. When doing this, insert the flange shaft centrally
into the shaft seal on the front differential -arrow-.
Note
If the flange shaft is not centered, the flange shaft splines -2-
♦
will damage the shaft seal between the final drive and the
transmission housing.
The shaft seal must be replaced if it is damaged.
♦
Ignore -arrow A-.
♦
– Tighten the left flange shaft mounting bracket -arrows-.
– After installing the transmission, check the axle oil level in the
front final drive and adjust if necessary. Refer to
⇒ "2.3 Gear Oil, Checking Level", page 151
4.2 Right Flange Shaft, Removing and In‐
stalling
Special tools and workshop equipment required
♦ Bearing/Bushing Installer - Multiple Use - VW295-
♦ Puller - Flanged Shaft - T10037-
8-Speed Automatic Transmission 0BK AWD - Edition 04.2017
.
.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Audi Q5 2008 ➤ , Audi Q5 China 2010 ➤
173
4. Differential