YASKAWA GA800 Technical Reference page 49

1.
Use the dimensions in
Figure 2.15 Panel Cut-Out Dimensions to Attach Inside Control Panel
W
64 + 0.5
(2.52 + 0.02)
2.
Remove the keypad and put the keypad connector in the holder on the front cover.
Note:
Insert the end of the keypad connector that has the tab.
A - Keypad
B - Keypad connector
3.
Use the screws included with the mounting bracket, and attach the keypad to the mounting bracket.
Use the screws included with the installation support set to attach it. Tighten the screws to a correct tightening
torque:
• M3 screws: 0.49 N∙m to 0.73 N∙m (4.34 lbf∙in to 6.46 lbf∙in)
YASKAWA SIEPC71061737D GA800 Drive Technical Reference
2.7 Install the Keypad in a Control Panel or Another Device
Figure 2.15 and Table 2.10
Table 2.10 Panel Cut-Out Dimensions mm (in)
H
130
(5.12)
Figure 2.16 Remove the Keypad
to cut an opening in the control panel for the keypad.
W1 H1
45 105 + 0.5
(1.77) (4.13 + 0.02)
C - Holder
d
4.8
(0.12)
2
49