YASKAWA GA800 Technical Reference page 920

12.8 H: Terminal Functions
■
15: Frequency Detection 3
Setting Value Function
15 Frequency Detection 3
Note:
• The detection level set in L4-03 is a signed value. The drive will only detect in one direction.
• The drive outputs the motor speed status when A1-02 = 3, 7 [Control Method Selection = CLV, CLV/PM].
ON : The output frequency is less than the value of L4-03 or is not higher than the value of L4-03 +
L4-04.
OFF : The output frequency is higher than the value of L4-03 + L4-04.
Figure 12.97 Example of Frequency Detection 3 (value of L4-03 Is Positive)
Note:
Figure 12.97 shows the time chart when L4-07 = 1 [Speed Agree Detection Selection = Detection Always Enabled]. The default setting of
L4-07 is 0 [No detection during baseblock]. When the speed agreement detection selection is "No Detection during Baseblock", the terminal
is deactivated when the drive output stops.
■
16: Frequency Detection 4
Setting Value Function
16 Frequency Detection 4
Note:
• The detection level set in L4-03 is a signed value. The drive will only detect in one direction.
• The drive outputs the motor speed status if A1-02 = 3, 7 [Control Method Selection = CLV, CLV/PM].
920
Figure 12.96 Example of User-set Speed Agree 2 (L4-03 Is Positive)
V/f CL-V/f OLV
The terminal deactivates when the output frequency > "L4-03 [Speed Agree Detection Level(+/-)] + L4-04 [Speed Agree Detection
Width(+/-)]". After the terminal deactivates, the terminal stays deactivated until the output frequency is at the value of L4-03.
V/f CL-V/f OLV
The terminal activates when the output frequency > L4-03 [Speed Agree Detection Level(+/-)]. After the terminal activates, the
terminal stays activated until the output frequency is at the value of "L4-03 - L4-04".
Description
CLV AOLV OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
Description
CLV AOLV OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
YASKAWA SIEPC71061737D GA800 Drive Technical Reference