YASKAWA GA800 Technical Reference page 472

8.5 Replace the Drive
1.
Pull the wiring cover away from the drive to remove it.
Note:
6-Phase/12-pulse drives (models: Txxx) do not have the wiring covers.
A - Wiring cover
2.
Loosen the main circuit terminal block screws to fully open the terminal block opening.
Note:
The terminal block openings ship from the factory as fully open.
3.
Put wires with prepared ends into the main circuit terminal block.
Note:
If there is a jumper between terminals +1 and +2, loosen the terminal block screws to remove the jumper before you wire to
terminals +1 and +2.
4.
Tighten the screws to the specified torque.
472
A B
B - Main circuit terminal block
Figure 8.88 Remove the Wiring Cover
Figure 8.89 Loosen Terminal Block Screws
Figure 8.90 Install the Electrical Wire
Figure 8.91 Tighten Terminal Block Screws
YASKAWA SIEPC71061737D GA800 Drive Technical Reference