YASKAWA GA800 Technical Reference page 471

Screw Size Screw Shape
M4
*1
M5
M6
M8
M10
*1 When wiring drive models 2056, 4089, and smaller, select the correct tools for the wire gauge.
*2 Use 6.35 mm (0.25 in) bit socket holder.
*3 Use a torque wrench that can apply this torque measurement range.
■
Remove the Control Circuit Terminal Block
Remove the keypad and the drive front cover before doing these steps.
1.
Loosen the screws on the control circuit terminal block.
2.
Slide the wired control circuit terminal block down and remove it.
■
Wire a New Drive
Remove the keypad, front cover, and control circuit terminal block of the new drive. Wire the drive to the main circuit
terminal block before you install a wired control circuit terminal block.
YASKAWA SIEPC71061737D GA800 Drive Technical Reference
Table 8.13 Recommended Wiring Tools
Adapter
Model
Bit SF-BIT-SL 1,0X4,0-70
Bit SF-BIT-SL 1,2X6,5-70
Bit SF-BIT-HEX 5-50
Bit SF-BIT-SL 1,2X6,5-70
Bit SF-BIT-HEX 6-50
Bit SF-BIT-HEX 8-50
Figure 8.86 Loosen the Screws
Figure 8.87 Remove the Control Circuit Terminal Block
Bit
Torque Driver Model
(Tightening Torque)
Manufacturer
TSD-M 3NM
PHOENIX CONTACT
(1.2 - 3 N∙m
(10.6 - 26.6 lbf∙in))
Wire Gauge ≤
25 mm
(AWG 10):
TSD-M 3NM
(1.2 - 3 N∙m
(10.6 - 26.6 lbf∙in))
PHOENIX CONTACT
Wire Gauge ≥
30 mm
(AWG 8): -
PHOENIX CONTACT -
PHOENIX CONTACT -
PHOENIX CONTACT -
PHOENIX CONTACT -
8.5 Replace the Drive
Torque Wrench
-
2
Wire Gauge ≤
25 mm 2
(AWG 10): -
Wire Gauge ≥
2
30 mm
2
(AWG 8):
4.1 - 4.5 N∙m
*2 *3
(36.3 - 39.8 lbf∙in)
5 - 9 N∙m
*2 *3
(44.3 - 79.9 lbf∙in)
3 - 3.5 N∙m
*2 *3
(26.6 - 31.0 lbf∙in)
8 - 12 N∙m
*2
(70.8 - 106.2 lbf∙in)
*3
12 - 14 N∙m
*2
(106.2 - 123.9 lbf∙in)
*3
471
8