YASKAWA GA800 Technical Reference page 137

5.
Remove the main circuit terminal block nut.
A - Nut
6.
Wire the closed-loop crimp terminal to the main circuit terminal block.
7.
Tighten the nut to the specified torque.
8.
Attach the wiring cover and terminal block cover to their initial positions and tighten the screws on the terminal
block cover.
Note:
6-Phase/12-pulse drives (models: Txxx) do not have the wiring covers.
YASKAWA SIEPC71061737D GA800 Drive Technical Reference
Figure 3.82 Remove the Terminal Block Nut
Figure 3.83 Connect the Wire
Figure 3.84 Tighten the Terminal Block Nut
3.9 Braking Resistor Installation
3
137