YASKAWA GA800 Technical Reference page 40

2.4 Moving the Drive
1.
Put wire through the 2 holes in the hanging brackets.
A - Suspension angle of at least 50 degrees
2.
Use a crane to gradually wind up the wire. Visually make sure that there is sufficient tension in the wire, then
lift the drive to its correct location. 3. Prepare the control panel for installation, then lower the drive.
3.
Prepare the control panel for installation, then lower the drive.
Note:
When lowering the drive, stop before the drive touches the floor, then slowly lower it the remaining distance.
■
Horizontal Suspension
If a horizontal suspension is required in the installation environment, hang the drive through the following steps.
Put the drive on the ground horizontally. Connect wires to the 4 hanging brackets and use a crane to lift the drive.
NOTICE: When you attach a horizontal lifting cable or chain to the drive, use a jig or pad between the wire and the drive. The wire
can scratch the drive and cause damage to the drive.
A - Hanging bracket (4)
40
B - Hanging bracket (2)
Figure 2.5 Vertical Suspension
Figure 2.6 Horizontal Suspension
YASKAWA SIEPC71061737D GA800 Drive Technical Reference