H2 Mfdo Parameters - YASKAWA GA800 Technical Reference

Note:
• When you use the function to output logical calculation results, you cannot set H2-01 to H2-03 = 1xx [Inverse Output of xx]. If you do, the
drive will detect oPE33 [Digital Output Selection Error].
• When you do not use H2-60, H2-63, and H2-66, set them to F. The through mode function is not supported.
◆

H2 MFDO Parameters

■
H2-01: Term M1-M2 Function Selection
No.
Name
(Hex.)
H2-01 Term M1-M2 Function
Selection
(040B)
Note:
When you do not use the terminal or when you use the terminal in through mode, set this parameter to F.
■
H2-02: Term M3-M4 Function Selection
No.
Name
(Hex.)
H2-02 Term M3-M4 Function
Selection
(040C)
Note:
When you do not use the terminal or when you use the terminal in through mode, set this parameter to F.
■
H2-03: Term M5-M6 Function Selection
No.
Name
(Hex.)
H2-03 Term M5-M6 Function
Selection
(040D)
Note:
When you do not use the terminal or when you use the terminal in through mode, set this parameter to F.
■
H2-06: Watt Hour Output Unit Selection
No.
Name
(Hex.)
H2-06 Watt Hour Output Unit
Selection
(0437)
This output is input to the Watt hour meter or PLC through a 200 ms pulse signal. This parameter sets the kWh unit
for each pulse output.
Note:
• When the power value is a negative value (regenerative state), the drive does not count Watt hours.
• When the control power supply to the drive is operating, the drive will keep the Watt hours. If a momentary power loss causes the drive to
lose control power, the Watt hour count will reset.
YASKAWA SIEPC71061737D GA800 Drive Technical Reference
V/f CL-V/f OLV CLV
Sets the function for MFDO terminal M1-M2.
V/f CL-V/f OLV CLV
Sets the function for MFDO terminal M3-M4.
V/f CL-V/f OLV CLV
Sets the function for MFDO terminal M5-M6.
V/f CL-V/f OLV CLV
Sets the unit for the output signal when H2-01 to H2-03 = 39 [MFDO Function Selection = Watt
Hour Pulse Output].
Figure 12.88 Example MFDO when Configured for Watt Hours
Description
AOLV OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
Description
AOLV OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
Description
AOLV OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
Description
AOLV OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
12.8 H: Terminal Functions
Default
(Range)
0
(0 - 1FF)
Default
(Range)
1
(0 - 1FF)
Default
(Range)
2
(0 - 1FF)
Default
(Range)
0
(0 - 4)
12
907