YASKAWA GA800 Technical Reference page 107

Screw Size Screw Shape
M6
M8
M10
*1 When wiring drive models 2056, 4089, and smaller, select the correct tools for the wire gauge.
*2 Use 6.35 mm (0.25 in) bit socket holder.
*3 Use a torque wrench that can apply this torque measurement range.
■
Main Circuit Terminal Block Wiring Procedure
Remove the keypad and front cover before wiring the main circuit terminal block.
1.
Pull the wiring cover away from the drive to remove it.
Note:
6-Phase/12-pulse drives (models: Txxx) do not have the wiring covers.
A - Wiring cover
2.
Put the end of a prepared wire into the terminal block.
Note:
If there is a jumper between terminals +1 and +2, loosen the terminal block screws and remove the jumper before wiring the
terminals.
YASKAWA SIEPC71061737D GA800 Drive Technical Reference
3.4 Main Circuit Terminal Block Wiring Procedure
Adapter
Model
Bit SF-BIT-HEX 5-50
Bit SF-BIT-SL 1,2X6,5-70
Bit SF-BIT-HEX 6-50
Bit SF-BIT-HEX 8-50
Figure 3.36 Remove the Wiring Cover
Figure 3.37 Install the Electrical Wire
Bit
Torque Driver Model
(Tightening Torque)
Manufacturer
PHOENIX CONTACT -
PHOENIX CONTACT -
PHOENIX CONTACT -
PHOENIX CONTACT -
Torque Wrench
5 - 9 N∙m
*2 *3
(44.3 - 79.9 lbf∙in)
3 - 3.5 N∙m
*2 *3
(26.6 - 31.0 lbf∙in)
8 - 12 N∙m
*2
(70.8 - 106.2 lbf∙in)
*3
12 - 14 N∙m
*2
(106.2 - 123.9 lbf∙in)
*3
3
107