YASKAWA GA800 Technical Reference page 459

3.
Remove the circuit board cooling fan units.
4.
Remove the screws that safety the circuit board cooling fans and remove the fans.
A - Circuit board cooling fan
■
Circuit Board Cooling Fan Installation
Reverse the removal procedure for fan installation.
1.
Align the pin on the fan unit base with the notch on the fan and put the circuit board cooling fan in the fan unit,
then use the screws to safety the circuit board cooling fan to the fan unit base.
Tighten the screws to a correct tightening torque:
• 0.98 N∙m to 1.33 N∙m (8.67 lbf∙in to 11.77 lbf∙in)
Note:
Make sure that you do not pinch cables between the circuit board cooling fan and the fan unit base.
A - Circuit board cooling fan
B - Fan unit base
2.
Put the circuit board cooling fan unit into the specified location and slide it down, then use the screws to safety
it to the drive.
Tighten the screws to a correct tightening torque:
• 0.98 N∙m to 1.33 N∙m (8.67 lbf∙in to 11.77 lbf∙in)
YASKAWA SIEPC71061737D GA800 Drive Technical Reference
Figure 8.61 Remove the Circuit Board Cooling Fan Units
Figure 8.62 Remove the Circuit Board Cooling Fans
Figure 8.63 Install the Circuit Board Cooling Fan
8.4 Replace Cooling Fans and Circulation Fans
B - Fan unit base
C - Alignment pin on fan unit base
8
459