YASKAWA GA800 Technical Reference page 948

12.8 H: Terminal Functions
0 : 0.1 V units
1 : 1 V units
■
H5-11: Comm ENTER Command Mode
No.
Name
(Hex.)
H5-11 Comm ENTER Command
Mode
(043C)
0 : ENTER Command Required
You must use the Enter command to enable changes to parameters. Make all parameter changes then input the Enter
command.
1 : ENTER Command Not Required
It is not necessary to input the Enter command to change parameters.
■
H5-12: Run Command Method Selection
No.
Name
(Hex.)
H5-12 Run Command Method
Selection
(043D)
0 : FWD/Stop, REV/Stop
The drive uses bit 0 in command data 0001H of the MEMOBUS register in the motor forward Run command (bit 0 =
1) and the stop command (bit 0 = 0). The drive uses bit 1 in the motor reverse Run command (bit 1 = 1) and the stop
command (bit 1 = 0).
1 : Run/Stop, FWD/REV
The drive uses bit 0 in command data 0001H of the MEMOBUS register in the motor Run command (bit 0 = 1) and
the stop command (bit 0 = 0). The drive uses bit 1 in the direction of motor rotation command (Forward run (bit1 = 0)
or Reverse run (bit 1 = 1)).
■
H5-17: ENTER command response @CPU BUSY
No.
Name
(Hex.)
H5-17 ENTER command response
@CPU BUSY
(11A1)
Expert
0 : Ignore Command(No ROM/RAM Write)
1 : Write to RAM Only
■
H5-18: Motor Speed Filter over Comms
No.
Name
(Hex.)
H5-18 Motor Speed Filter over
Comms
(11A2)
Sets the filter time constant when you monitor the output frequency or motor speed during MEMOBUS/Modbus
communications or use of the communication option.
These are the MEMOBUS registers:
• 003EH (Output Frequency)
• 003FH (Output Frequency)
• 0044H (U1-05: Motor Speed)
948
V/f CL-V/f OLV CLV AOLV
Sets the function to make the Enter command necessary to change parameters through MEMOBUS/
Modbus communications.
V/f CL-V/f OLV CLV AOLV
Sets the input method for the Run command when b1-02 = 2 [Run Command Selection 1 =
Memobus/Modbus Communications] or b1-16 = 2 [Run Command Selection 2 = Memobus/Modbus
Communications].
V/f CL-V/f OLV CLV AOLV
Sets operation when the EEPROM write command is sent without EEPROM write available. Usually
it is not necessary to change this setting.
V/f CL-V/f OLV CLV AOLV
Sets the filter time constant used when monitoring motor speed during MEMOBUS/Modbus
communications or with a communication option.
Description
OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
Description
OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
Description
OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
Description
OLV/PM AOLV/PM CLV/PM EZOLV OLV/PM
YASKAWA SIEPC71061737D GA800 Drive Technical Reference
Default
(Range)
0
(0, 1)
Default
(Range)
0
(0, 1)
Default
(Range)
0
(0, 1)
Default
(Range)
0 ms
(0 - 100 ms)