YASKAWA GA800 Technical Reference page 136

3.9 Braking Resistor Installation
Refer to Cutaway Section of the Wiring Cover on page 133
Note:
• Different drive models have different wiring covers.
• Only clip the section of the wiring cover that applies to the wired terminal. If you clip areas that do not apply to wired terminals,
the protective enclosure will not keep its IP20 protective level.
• Make sure that you hold the cutaway section tightly when you remove pieces of the cutaway section. Pieces of the cutaway
section can fly out and cause injury.
• Make sure that the clipped section does not cause damage to the wires.
• If you use wires that are not specified by Yaskawa, the protective enclosure could lose its IP20 protective level, although the
wiring cover is correct. Contact Yaskawa or your nearest sales representative for more information.
• When you use the recommended gauge for the electrical wires, it is not necessary to attach the wiring cover of the main circuit
power input terminal and the drive output terminal. If you use the applicable gauge for the electrical wires, you must attach the
wiring cover.
3.
Put the wires through the holes that you cut out of the wiring cover.
Note:
6-Phase/12-pulse drives (models: Txxx) do not have the wiring covers.
A - Wire
4.
Crimp the closed-loop crimp terminal to the wire.
136
Figure 3.80 Clip the Cutaway Section of the Wiring Cover
Figure 3.81 Lead the Wire through the Wiring Cover
for more information.
YASKAWA SIEPC71061737D GA800 Drive Technical Reference