YASKAWA GA800 Technical Reference page 164

4.2 Keypad Components and Functions
Note:
• Energize the drive with factory defaults to show the Initial Setup screen. Push
–Select [No] from the [Show Initial Setup Screen] setting to not display the Initial Setup screen.
• Push
from the Home screen to show drive monitors.
• Push
to set d1-01 [Reference 1] when the Home screen shows U1-01 [Frequency Reference] in LOCAL Mode.
• The keypad will show [Rdy] when the drive is in Drive Mode. The drive is prepared to accept a Run command.
• Set b1-08 [Run Command Select in PRG Mode] to accept or reject a Run command from an external source while in Programming Mode.
–Set b1-08 = 0 [Disregard RUN while Programming] to reject the Run command from an external source while in Programming Mode
(default).
–Set b1-08 = 1 [Accept RUN while Programming] to accept the Run command from an external source while in Programming Mode.
–Set b1-08 = 2 [Allow Programming Only at Stop] to prevent changes from Drive Mode to Programming Mode while the drive is
operating.
Mode
Drive Mode Monitors
Parameters
User Custom Parameters
Parameter Backup/Restore
Programming Mode Modified Parameters/Fault Log
Auto-Tuning
Initial Setup Screen
Diagnostic Tools
164
Table 4.3 Drive Mode Screens and Functions
Keypad Screen
Sets monitor items to display.
Changes parameter settings.
Shows the User Parameters.
Saves parameters to the keypad as backup.
Shows modified parameters and fault history.
Auto-Tunes the drive.
Changes initial settings.
Sets data logs and backlight.
[Home] to show the HOME screen.
Function
YASKAWA SIEPC71061737D GA800 Drive Technical Reference