Configure The Ix14 Device To Use Custom Factory Default Settings - Digi IX14 User Manual

Hide thumbs Also See for IX14:

Table of Contents

System administration

Password: Use the unique password printed on the bottom label of the device (or the

printed label included in the package).

If your device was manufactured prior to the release of firmware version 19.11.x, the

default user name may be root.

c. (Optional) Reset the default password for the admin account. See

password for the admin user

Reset the device with the revert command

You can reset the device to the default configuration without removing scripts, keys, and logfiles by

using the revert command:

1. Log into the IX14 command line as a user with full Admin access rights.

Depending on your device configuration, you may be presented with an Access selection

menu. Type admin to access the Admin CLI.

2. At the command line, type config to enter configuration mode:

3. At the config prompt, enter revert:

(config)> revert

4. Set the password for the admin user prior to saving the changes:

(config)> auth user admin password pwd

5. Save the configuration and apply the change:

(config)> save

Configuration saved.

6. Type exit to exit the Admin CLI.

Depending on your device configuration, you may be presented with an Access selection

menu. Type quit to disconnect from the device.

Configure the IX14 device to use custom factory default settings

You can configure your IX14 device to use custom factory default settings. This way, when you erase

the device's configuration, the device will reset to your custom configuration rather than to the

original factory defaults.

To clear the custom default configuration, press the RESET button, wait for the device to reboot,

then press the RESET button again.

IX14 User Guide

Erase device configuration and reset to factory defaults

for further information.

Change the default