Configure The Tx54 Device To Use Custom Factory Default Settings - Digi TX54 User Manual

System administration
When you first log into the WebUI or the command line, you will be required the change
the SSIDs and pre-shared keys (passwords) for the preconfigured Wi-Fi access points
before you can save any configuration changes. See
keys for the preconfigured Wi-Fi access points
c. (Optional) Reset the default password for the admin account. See
password for the admin user
Reset the device with the revert command
You can reset the device to the default configuration without removing scripts, keys, and logfiles by
using the revert command:
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. At the config prompt, enter revert:
(config)> revert
(config)>
4. Set the password for the admin user prior to saving the changes:
(config)> auth user admin password pwd
(config)>
5. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Configure the TX54 device to use custom factory default settings

You can configure your TX54 device to use custom factory default settings. This way, when you erase
the device's configuration, the device will reset to your custom configuration rather than to the
original factory defaults.
Note To clear the custom default configuration, press the RESET button, wait for the device to reboot,
then press the RESET button again.
Required configuration items
Custom factory default file
n
TX54 User Guide
Erase device configuration and reset to factory defaults
Reset default SSIDs and pre-shared
for instructions.
for further information.
Change the default
834