Configure The Lr54 Device To Use Custom Factory Default Settings - Digi LR54 User Manual

System administration
Wi-Fi access points before you can save any configuration changes. See
SSIDs and pre-shared keys for the preconfigured Wi-Fi access points
c. (Optional) Reset the default password for the admin account. See
password for the admin user
Reset the device with the revert command
You can reset the device to the default configuration without removing scripts, keys, and logfiles by
using the revert command:
1. Select the device in Remote Manager and click Actions > Open Console, or log into the LR54
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. At the config prompt, enter revert:
(config)> revert
(config)>
4. Set the password for the admin user prior to saving the changes:
(config)> auth user admin password pwd
(config)>
5. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Configure the LR54 device to use custom factory default settings

You can configure your LR54 device to use custom factory default settings. This way, when you erase
the device's configuration, the device will reset to your custom configuration rather than to the
original factory defaults.
Note To clear the custom default configuration, press the RESET button, wait for the device to reboot,
then press the RESET button again within five minutes. If the RESET button is pressed again after 5
minutes, the custom default configuration will not be cleared, in which case you will need to restart
the process.
LR54 User Guide
Erase device configuration and reset to factory defaults
for further information.
Reset default
for instructions.
Change the default
931