Configure An Ip Address From The Command-Line Interface; Ip Addresses And The Idigi Platform; Test The Ip Address Configuration - Digi TS 8 MEI User Manual

Configure an IP address from the command-line interface

The set network command configures an IP address from the command line. Include the following
parameters:





For example:
To configure the Digi Connect SP through the command line, the DIP switches must be changed.
See "Command line access" on page 123 for an illustration of the DIP switch settings.

IP addresses and the iDigi Platform

From the iDigi Platform interface the Ethernet/LAN address for a Digi device can be changed
only; an address cannot be assigned. The mobile/cellular device is typically provided by the
mobile service provider; check with your mobile service provider on how they handle addresses.
To change the IP address, open the web interface for based on the IP address the device has and
navigate to Configuration > Network > IP Settings. On the IP Settings page, enter the new IP
address, subnet mask, and gateway.

Test the IP address configuration

Once the IP address is assigned, make sure it works as configured.
1
2
ip=device ip: The IP address for the device.
gateway=gateway: The network gateway IP address.
submask=device submask: The device subnet mask.
dhcp=off: Turns off use of the Dynamic Host Configuration Protocol (DHCP), so that
the IP address assigned is permanent.
static=on: Specifies that the IP address is static, and will remain as the specified IP
address, gateway, and submask.
set network ip=10.0.0.100 gateway=10.0.0.1
submask=255.255.255.0 dhcp=off static=on
Access the command line of a PC or other networked device.
Issue the following command:
ping ip-address
where ip-address is the IP address assigned to the Digi device. For example:
ping 192.168.2.2
C o n f i g u r e D i g i d e v i c e s
4 9