The Revert Command - Digi Connect IT 16 User Manual

Hide thumbs Also See for Connect IT 16:

Table of Contents

Command line interface

The revert command

The revert command is used to revert changes to the Connect IT 16/48 device's configuration and

restore default configuration settings. The behavior of the revert command varies depending on

where in the configuration hierarchy the command is executed, and whether the optional path

parameter is used. After executing the revert command, you must save the configuration changes by

using the save command. You can also discard the configuration changes by using the cancel

CAUTION! The revert command reverts all changes to the default configuration, not only

unsaved changes.

Revert all configuration changes to default settings

To discard all configuration changes and revert to default settings, use the revert command at the

config prompt without the optional path parameter:

1. At the config prompt, enter revert:

(config)> revert

2. Set the password for the admin user prior to saving the changes:

(config)> auth user admin password pwd

3. Save the configuration and apply the change:

(config)> save

Configuration saved.

4. Type exit to exit the Admin CLI.

Depending on your device configuration, you may be presented with an Access selection

menu. Type quit to disconnect from the device.

Revert a subset of configuration changes to the default settings

There are two methods to revert a subset of configuration changes to the default settings.

Enter the revert command with the path parameter. For example, to revert all changes to the

authentication methods configuration:

1. Enter the revert command with the path set to auth method:

(config)> revert auth method

2. Save the configuration and apply the change:

(config)> save

Configuration saved.

Digi Connect IT® 16/48 User Guide

Configuration mode

Connect it 48