Set Trace; Set Usb; Set Web; Set Xbee - Digi ConnectPort LTS8 Command Reference Manual

Introduction
Feature/Task
Status of your ConnectPort
LTS product
Telnet to network devices
LCD
NFS
Samba
SD memory
Syslog
Trace
USB
Web
XBee

Access the command line

To configure devices using commands, you must first access the command line, and then log on as
needed.
This procedure assumes that you have already configured the ConnectPort LTS product with an IP
address.
1. To access the command-line interface for the ConnectPort LTS product, enter the following
command from a command prompt on another networked device, such as a server:
telnet
Or
ssh user@ ip address
Where:
ip address is the ConnectPort LTS product's IP address.
user is the username on ConnectPort LTS product.
For example:
telnet 192.3.23.5
Or
ssh root@192.2.23.5
Or connect to the serial console port with a terminal emulator.
ConnectPort® LTS Command Reference
Commands
display
status
who
telnet
set lcd
set nfs
set samba
set sdmemory
set syslog

set trace

set usb

set web

set xbee

ip address
Access the command line
8