Assign An Ip Address From The Web Interface; Test The Ip Address Assignment - Digi ConnectPort LTS Series User Manual

Get started with ConnectPort LTS products
ip_v6=device ip: The IP v6 address for the device.
n
gateway_v6=gateway: The IP address for the IP v6 network gateway.
n
submask_v6=gateway: The device subnet mask for the IP v6 address.
n
mode+v6=(none|static|dhcp): The configuration mode of the IP v6 address.
n
For example:
set network index=1 ip_v4=10.0.0.100 gateway_v4=10.0.0.1 submask_v4=255.255.255.0
mode_v4=static

Assign an IP address from the web interface

Normally, you assign IP addresses to ConnectPort LTS devices through DHCP. This procedure
assumes that the ConnectPort LTS device already has an IP address and you simply want to change it.
To change the IP address from the web interface:
1. Open a web browser and type the current IP address of the ConnectPort LTS device in the
address bar. A login dialog displays.
2. Enter the default user name and password for the device.
User name: The default user name is root.
n
Password: The unique default password is printed on the device label. If the password is
n
not on the device label, the default password is dbps. If neither of the defaults work,
the password may have been updated. Contact your system administrator.
Note If this is the first time you have logged into the web interface, you are required to change
the password.
3. Click Network to access the Network Configuration page.
4. On the IP Settings page, select Use the following IP address.
5. Type the IP address, subnet mask, and gateway settings.
6. Click Apply to save the configuration.

Test the IP address assignment

To verify the IP address works as configured:
1. Access the command line of a computer or other networked device.
2. Issue the following command:
ping ip-address
where ip-address is the IP address assigned to the Digi device. For example:
ping 192.168.2.2
Digi ConnectPort LTS User Guide
Test the IP address assignment
23