Table of Contents
Advertisement
Services
Repeat this step to list additional firewall zones.
6. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
7. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Example performance test using iPerf3
On a remote host with iPerf3 installed, enter the following command:
$ iperf3 -c device_ip
where device_ip is the IP address of the Connect IT 16/48 device. For example:
$ iperf3 -c 192.168.2.1
Connecting to host 192.168.2.1, port 5201
[
4] local 192.168.3.100 port 54934 connected to 192.168.1.1 port 5201
[ ID] Interval
[
4]
0.00-1.00
[
4]
1.00-2.00
[
4]
2.00-3.00
[
4]
3.00-4.00
[
4]
4.00-5.00
[
4]
5.00-6.00
[
4]
6.00-7.00
[
4]
7.00-8.00
[
4]
8.00-9.00
[
4]
9.00-10.00
- - - - - - - - - - - - - - - - - - - - - - - - -
[ ID] Interval
[
4]
0.00-10.00
[
4]
0.00-10.00
iperf Done.
$
Digi Connect IT® 16/48 User Guide
---------------------------------------------------------
----------------------
any
dynamic_routes
edge
external
internal
ipsec
loopback
setup
(config)>
Transfer
sec
26.7 MBytes
sec
28.4 MBytes
sec
29.8 MBytes
sec
31.2 MBytes
sec
32.1 MBytes
sec
32.5 MBytes
sec
33.9 MBytes
sec
33.7 MBytes
sec
33.5 MBytes
sec
33.2 MBytes
Transfer
sec
315 MBytes
sec
313 MBytes
Bandwidth
Retr
224 Mbits/sec
8
238 Mbits/sec
29
250 Mbits/sec
0
262 Mbits/sec
0
269 Mbits/sec
0
273 Mbits/sec
0
284 Mbits/sec
0
282 Mbits/sec
0
281 Mbits/sec
0
279 Mbits/sec
0
Bandwidth
Retr
264 Mbits/sec
37
262 Mbits/sec
Use the iPerf service
Cwnd
2.68 MBytes
1.39 MBytes
1.46 MBytes
1.52 MBytes
1.56 MBytes
1.58 MBytes
1.60 MBytes
1.60 MBytes
1.60 MBytes
1.60 MBytes
sender
receiver
435
Advertisement
Table of Contents
