Download Mibs - Digi Connect IT 16 User Manual

Services
5. Set the name of the user that will be used to connect to the SNMP agent.
(config)> service snmp username name
(config)>
6. Set the password for the user that will be used to connect to the SNMP agent:
(config)> service snmp password pwd
(config)>
7. (Optional) Set the port number for the SNMP agent. The default is 161.
(config)> service snmp port port
(config)>
8. (Optional) Configure Multicast DNS (mDNS)
mDNS is a protocol that resolves host names in small networks that do not have a DNS server.
For the SNMP agent, mDNS is disabled by default. To enable:
(config)> service snmp mdns enable true
(config>
9. (Optional) Set the authentication type. Allowed values are MD5 or SHA. The default is MD5.
(config)> service snmp auth_type SHA
(config)>
10. (Optional) Set the privacy passphrase. If not set, the password, entered above, is used.
(config)> service snmp privacy pwd
(config)>
11. (Optional) Set the privacy protocol, either DES or AES. The default is DES.
(config)> service snmp privacy_protocol AES
(config)>
12. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
13. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Download MIBs

This procedure is available from the WebUI only.
Required configuration items
Enable SNMP.
n
Digi Connect IT® 16/48 User Guide
Simple Network Management Protocol (SNMP)
365