Setting Speed Of The Registration Mark Scan - GRAPHTEC CE7000 Series User Manual

Setting speed of the registration mark scan

Speed of the tool carriage and media to scan the registration mark is set.
It may not scan the registration marks or the difference may become large when the speed is too high, but the
cutting time becomes longer when the speed is too slow. Adjust the setting value considering the balance.
If the registration mark cannot be scanned or the error is large, setting a low (slower) value may improve the
scanning.
Operation
1
Press the [PAUSE/MENU] key.
MENU screen is displayed.
2
Press the [2] key (ARMS).
ARMS SETTING screen (1/3) is displayed.
3
Press the POSITION ( ) key.
ARMS SETTING screen (2/3) is displayed.
4
Press the [3] key (SENSING SPEED).
SENSING SPEED screen is displayed.
5
Press the POSITION (
setting value.
) keys and increase or decrease the
5-25
Supplement
Perform the settings in Normal mode.
Supplement
It will return to ARMS SETTING screen (2/3)
without changing the settings when you press
the [ESC] key (CANCEL).
Supplement
You can set the range between 1 and 30 (cm/s).