Table of Contents
Advertisement
4-
4
Open the "Cutting Plotter" screen.
4-
5
Using the cutting plotter's POSITION (
the tool to the lower right registration mark (within the red
rectangle).
MARK TYPE 1
4-
6
Press the "Send to cutter".
When registration mark scanning starts and all registration
marks is completed to scan, cutting starts.
MARK TYPE 2
Move here
) key, move
Move here
13-14
Supplement
If a registration mark scanning error occurs,
check the registration marks etc. (See "ARMS".)
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the CE7000 Series and is the answer not in the manual?
Questions and answers