Setting The Registration-Mark Auto-Scan Mode - GRAPHTEC CE5000-60 User Manual

Setting the Registration-Mark Auto-Scan Mode

If the registration marks are at pre-determined positions on the medium, they can be scanned automati-
cally.
M A R K M O D E
M A R K P O S I T I O N
M A R K T Y P E
M A R K S I Z E
M A R K D I S T . A D J .
M A R K O F F S E T
M A R K S E N S O R A D J 1
M A R K S E N S O R A D J 2
M A R K A U T O S C A N
M A R K S E N S O R A D J
1
Step
Press the (PAUSE) key to switch to PAUSE mode.
2
Step
Press the (NEXT) or
A U T O R E G . M A R K
3
Step
Press the (ENTER) key to display the Auto Reg. Mark submenu, and then press the
(PREV.) key until the following menu is displayed.
M A R K A U T O S C A N
4
Step
Press the (ENTER) key to display the Auto-scan mode setting.
A U T O S C A N
5
Step
Press the or key to select "ON" or "OFF," and then press the
the selection, press the
When ON
Registration-mark pattern 1
was selected
Point 4
(the desired Origin Point)
Point 3
Move the pen tip within this area
100mm
When OFF
Registration-mark pattern 1
was selected
Point 4
(the desired Origin Point)
Point 3
Move the pen tip within this area
(PREV.) key until the following menu is displayed.
O N
(NEXT) or (PREV.) key.
Point 2
Point 4
Point 1
Point 2
Point 4
Point 1
4 – 20
Registration-mark pattern 2
Point 2
Point 3
Point 1
(the desired
Origin Point)
Move the pen tip within this area
Registration-mark pattern 2
Point 2
Point 3
Point 1
(the desired
Origin Point)
Move the pen tip within this area
(NEXT) or
(ENTER) key to confirm. To cancel
X
Y
X
Y