GRAPHTEC CE7000 Series User Manual page 130

6
Press the [2] key (NUMBER OF COPIES).
NUMBER OF COPIES screen is displayed.
7
Press the POSITION (
setting value.
8
Confirm the setting and press the [ESC] key (PREVIOUS).
Number of copies will be selected, and it will return to COPY MODE
screen.
9
Press the [3] key (COPY SPACE).
COPY SPACE screen is displayed.
10
PPress the POSITION (
the setting value.
11
Confirm the setting and press the [ESC] key (PREVIOUS).
Copy space will be selected, and it will return to COPY MODE screen.
12
Confirm the setting and press the [ENTER] key (SET).
"COPY" is displayed on the screen, and it will copy as much as
specified.
) keys and increase or decrease the
) keys and increase or decrease
4-12
Supplement
•
Number of copies can be set as much as it
can fit in the media set on the printer.
•
The initial value for the number of copies is
always 1.
Supplement
"CANNOT COPY CUT AREA TOO SMALL!" is
displayed if the cutting area is smaller than the
copy data. Either expand the cutting area, or set
the media that is big enough to copy.
Supplement
•
Copy interval can be set when MEDIA
CHANGE MODE is turned OFF.
•
Copy space can be set from 1.0 mm to 10.0
mm.
•
This setting is maintained even if the power is
turned off.
Supplement
Cutting data is stored even if the media is
exchanged. It can be copied as many times until
the buffer memory is cleared. It can be copied
again after exchanging the media by pressing
[COPY] key.