GRAPHTEC CE7000 Series User Manual page 298

5
Press the [1] key (BLADE WEAR DETECT.).
BLADE WEAR DETECT. screen is displayed.
6
Press the [1] key (ON) or the [2] key (OFF).
7
Confirm the setting and press the [ENTER] key (SET).
Setting will be confirmed and it will return to BLADE WEAR DETECT.
screen.
8
Press the [2] key (SET BLADE GROUP).
SET BLADE GROUP screen is displayed.
9
Press the POSITION (
No. (CONDITION No.).
10
Press the POSITION (
setting value.
11
Confirm the setting and press the [ENTER] (SET).
Setting will be confirmed and it will return to BLADE WEAR ALARM
SETUP screen
) key to select the Tool Condition
) key and increase or decrease the
14-8
Supplement
You can set the range between 1 and 8.
Supplement
You can set the range between 0 and 8.
When set to 0, the alarm will not belong to any
group.