GRAPHTEC CE7000 Series User Manual page 246

4
Press the [3] key (BARCODE CUT).
The following message is displayed.
5
Press the [1] key (STANDARD BARCODE ) or the [2] key
(ROLL MEDIA BARCODE ).
The following display is displayed.
<Standard bar code>
6
Press the POSITION (
start mark position.
7
Confirm the tool position and press the [ENTER] key.
The bar code is scanned. On completing it, the following screen is
displayed.
<Roll media bar code>
) key to move the tool to the
12-6
Supplement
•
If the USB memory is not inserted, the
following is displayed.
•
When the Rotation is set to ON, the following
display is displayed.
•
When the Mirror is set to ON, the following
display is displayed.
•
When the Panel Cutting is set to ON, the
following display is displayed.
•
In the case of a barcode of roll media, the
following will be displayed for the second and
subsequent sheets.
Supplement
•
If the start mark is not scanned the following
display is displayed.
Check the print result of start mark and the
detect start position etc.