Registration Mark Scan Settings; Setting The Scan Mode - GRAPHTEC CELITE-50 User Manual

5.6

Registration Mark Scan Settings

Setting the Scan Mode

Select the scan mode for the sensors to use in order to scan the registration marks. Select a mode according
to the media being used.
Once you are done with the setting, touch the
MODE 1: Select this mode when using common media with a white base.
MODE 2: Select this mode when using colored or glossy media.
MODE 3: Use this mode when using special materials and the registration marks cannot be scanned with
either MODE 1 or MODE 2.
Use the "MEDIA CHECK" function to serve as a reference when selecting the scan mode.
Also set the registration mark adjustment values as necessary. The registration mark adjustment values can be
set using "+" and "–".
When using MODE 1, decide the setting based on the darkness of the registration mark lines. Set "+" for dark
registration mark lines and "–" for light registration mark lines.
When using MODE 2 or MODE 3, decide the setting based on the contrast between the base and the
registration mark lines. Set "+" when the contrast is large and "–" when the contrast is small.
1.
From the "MENU" screen, open the "ARMS 1/2" screen.
2.
Under "ARMS MODE", touch the corresponding to the mode
you wish to select.
3.
To adjust the registration mark adjustment value, touch the
"ADJUST LEVEL".
If there is no need to make changes, touch the
4.
Use the " " and " " to select the setting value and confirm the
selection with the
(Exit) to return to the "HOME" screen.
(Confirm).
(Exit).
Chapter 5 Detailed Settings
5-13