Connecting To The Computer - GRAPHTEC CE7000 Series User Manual

1.4

Connecting to the Computer

Connect the plotter to the computer using the interface cable. Use one of the USB ports, the network (LAN)
interface or the RS-232C port to connect the plotter to the computer. Select the port depending on the specification
of the software to be used and the availability of the interface port on the computer.
Please install driver software before connecting.
Depending on the port used, use one of the USB cable (standard accessories), the network (LAN) cable
(commercially available product) or the RS-232C cable (commercially available product) to connect. Use the
cables specified by Graphtec, matching the computer that is to be connected.
* RS-232C interface depends on the sales area. For details, please contact the distributor where you purchased.
Connection
1
Check that the power switch is turned off (the " " side is
pressed down).
CE7000-40/60
2
Connect the plotter to the computer using the interface cable.
* This section explains in the CE7000-130.
Computer
Connection via USB interface
USB cable
(accessories)
CE7000-130/160
Supplement
See the "Setting Interface" for setting the
interface.
1-13