GRAPHTEC CE7000 Series User Manual page 276

5-
8 Using the the cutting plotter's POSITION (
the tool to the start mark (see figure) under the bar code and
press the [ENTER] key.
The bar code is scanned, the corresponding data is read
out from the USB memory, and cutting starts when the
registration mark is completed to scan.
MARK TYPE 1
Move the center of
the tool here
) key, move
MARK TYPE 2
Move the center of
the tool here
Start mark
13-22
Supplement
If the start mark cannot be scanned, check the
print result of start mark and the detect start
position etc.