Adjusting The Blade Length; Blade Application And Features - GRAPHTEC CE7000 Series User Manual

Adjusting the blade length

Blade length needs to be adjusted to perform optimal cut. Perform few test cuts and set the optimal blade length.
CAUTION
•
To avoid bodily injury, handle cutter blades with care.
•
It may result in damaging the cutter blade or the cutting mat if the blade is extended too much. Make sure the blade length is set less
than the thickness of the media.
After adjustment, please always perform "test cut".
Supplement
•
See "Running Cutting Tests" for cutting tests.
•
If a thin media such as a film is used, use the supplied magnifier to adjust it.
Adjust the blade length by turning the blade-length adjustment knob. Turn the knob in direction "A" to extend
the blade, or in direction "B" to retract the blade. When the knob is turned by one scale unit, the blade moves
approximately 0.1 mm. One full turn of the knob moves the blade approximately 0.5 mm.
Cutter blade moves
approximately 0.1 mm turning
one scale unit

Blade application and features

Select the optimal cutter blade and medium to be cut.
Refer to the Cutter Blade Manual.
CAUTION
To avoid bodily injury, handle cutter blades with care.
PHP33-CB09N-HS/PHP33-CB15N-HS
Scale
Scale
2-4