2
While pushing up the tool holder, push until its flange
completely touches the upper part of the holder.
3
Make sure that the bracket is engaged on the tool's flange,
and then tighten the screw.
Removing the tool
When removing the tool, turn it counterclockwise to remove the tool.
Bracket to hold tool
Tool holder
(Forward: Using cutting)
Seen from above
Bracket to hold tool
Tool holder
Flange
Tool holder
(Backward: Half cutting/Plotting Pen)
Flange
2-6
Supplement
When using with half cutting and plotter pen, set
the seal in Tool Holder (backward), and when
using cutting out (perforated cut), set the seal in
Tool Holder (forward).