Setting Cutting Width (Expand) - GRAPHTEC CE7000 Series User Manual

Setting cutting width (EXPAND)

Set the cutting width. It is possible to set that it will cut to the area outside of the push rollers, or not to cut at the
ends of the media.
Default setting is to the internal edge of the push rollers. It can be set up to 10 mm outside (positive value) or 10
mm inside (negative value) from the default position. The width will enlarge if the value is set to positive, and the
width will decrease if the value is set to negative. Setting will affect both ends, resulting the total width change
will be double the set value.
CAUTION
Do not set the "INITIAL BLADE CONTROL POSITION" of the tool setting to "OUTSIDE" when the setting value is set to more than 8
mm. The blade might be damaged by moving the carriage outside the media under this condition.
Supplement
•
If the value is set to positive, it is able to cut over where the push rollers are, but the push rollers passes where it is cut, creating a
chance of bad feeding depending on the media
•
Set the width of cutting area, and then send the cutting data to the plotter. Cutting data in the buffer memory will be cleared when
cutting area width is changed.
Operation
1
Press the [PAUSE/MENU] key in READY status.
MENU screen is displayed.
2
Press the [3] key (AREA).
AREA PARAMETERS screen (1/2) is displayed.
3
Press the POSITION ( ) key
AREA PARAMETERS screen (2/2) is displayed.
Supplement
Perform the settings in Normal mode.
4-4