Start Mark Auto Scan - GRAPHTEC CE7000 Series User Manual

12.4

Start Mark Auto Scan

When the start mark auto scan is set to ON, the following operation is performed.
If the tool is close to the start mark, pressing the [ENTER] key will automatically scan the start mark without
moving the tool to the scan start position.
Supplement
•
It is available only for the start mark of "standard bar code". For "Roll Paper Barcode" it is not available.
•
If a mask registration mark is being plotted, there is a possibility to recognize the mask registration mark as a start mark. If a mask
registration mark is being plotted, set the start mark auto scan to OFF.
Operation
1
Press the [PAUSE/MENU] key.
MENU screen is displayed.
2
Press the POSITION ( ) key (LINK).
DATA LINK screen (1/2) is displayed.
3
Press the POSITION ( ) key.
DATA LINK screen (2/2) is displayed.
4
Press the [1] key (START MARK AUTO SCAN).
START MARK AUTO SCAN screen is displayed.
5
Press the [1] key (ON) or the [2] key (OFF).
Supplement
Perform the settings in Normal mode.
12-8