Move Away The Tool Carriage - GRAPHTEC CE7000 Series User Manual

Move away the tool carriage

It is possible to move the tool carriage toward upper right. It makes it easier to confirm the cutting results if you
perform this operation after the cutting is completed.
To the top of the
maximum cutting area
Operation
1
Press the [1] key (TOOL1 VIEW) in READY status.
Tool carriage will move away.
To move the tool carriage to the origin point, do following:
Operation
1
Press the [2] key (HOME) in READY status.
Tool carriage will move to the origin point.
<When using Roll Media>: Seen from above
Standby position of the
pen carriage
Position of the pen carriage
before moving away
To the bottom of the cutting area
(machine origin point)
<When using Sheet Media>: Seen from above
100 mm
Bottom of the operation area
(machine origin point)
Supplement
When the tool number setting is set to "1", press
the "TOOL 1 MOVE AWAY", and when set to
"3", press the "TOOL 3 MOVE AWAY".
3-5