Advertisement
Refit the rear wheelhouses (
Connect the DEIS tester to the diagnostic socket (
Perform the "Fuel tank tightness test" cycle.
Replacing the fuel filler neck recess
Tightening torque
Fastening the fuel filler neck recess
Fastening fuel filler flap actuator
Disconnect the battery (
Remove the rear wheelhouses (
Remove the rear right hand wheelhouse.
E3.05).
Screw
Screw
F2.01).
E3.05).
Fit the fuel filler neck (A) in its seat in the right
hand wheel bay, after fitting the relative seal
between the neck and the seat (7).
Fit the ground cable (6) on the front stud bolt and
tighten the nuts (5) fastening the fuel filler
neck (A) to the bodyshell.
Tightening torque
Nut
Connect the condensation drain tube (4) to the
filler neck and fasten the clamp (3).
Connect the pipe (2) leading to the fuel tank onto
the filler neck and tighten the clamp (1).
F2.10).
Disconnect the connector (1).
Nm
Class
9 Nm
Nm
Class
4 Nm
B
2.6 Nm
B
B
Advertisement
