Advertisement
If the following conditions have been met:
1) the initial check cycle period for the instrument panel warning lights has elapsed;
2) engine speed has exceeded and remained above 700 rpm for at least 3 seconds;
3) the check cycle has been completed successfully (no failures);
4) the Service information has been displayed for five seconds.
The message "Check OK" is displayed against a green background in area D.
If only conditions 1, 3 and 4 have been met (engine not started), the main screen memorised previously
(even following a Key-off/Key-on cycle) is displayed immediately (without the "Check OK" message).
The "Check OK" message will be displayed as soon as condition 2 is met, provided that the other conditions
persist.
After the initial check cycle period for the instrument panel warning lights, the instrument panel waits a further
1000 ms before indicating any failures (with the exception of the warnings: "Minimum engine oil"
and/or "Inertia switch triggered" and/or "Electronically controlled gearbox safety warnings" and/or "EPB
disengaged" and/or "Parking brake on", which are displayed as soon as they are available) or until
the "Check OK" message to ensure that all warning light checks requested by the external ECUs have
been completed (within the warning light check display period).
During the diagnostic cycle ("Check in progress" screen displayed), should any of the following events
occur: "Low engine oil pressure" and/or "Inertia switch triggered" and/or "Electronically controlled gearbox
safety warnings" and/or "EPB disengaged" and/or "Parking brake on", the relative event is displayed
immediately (without interrupting the "Check in progress" screen), whereas, in the event of all other faults
(priority 0, 1 or 2), the fault is displayed only after the "Check in progress" screen display period has
elapsed.
In these cases, the display logic for diagnostic cycle progress is overridden and, once the fault display cycle
is complete, the standard screen or the currently active screen is displayed.
Safety messages relative to the electronically controlled gearbox are as follows:
depress brake pedal;
depress brake pedal and engage gear;
depress brake pedal and press PS to engage gear;
set gearbox lever to neutral;
delayed ignition;
reduce gear changes;
manual method unavailable;
automatic method unavailable;
gearbox not in Parking position;
carwash mode activation;
only manual unlock gearbox allowed: See manual.
Advertisement
