Advertisement
following conditions:
seat belt buckled;
driver side door closed;
engine on;
vehicle stationary;
brake pedal depressed.
The lever (A) operates the emergency brake (by operating the callipers) when the vehicle is in motion.
On vehicles with the DCT gearbox, pressing the AUTO PARK (B) button, after disengaging the EPB electric
parking brake as described previously and with the ignition key turned to II (Key-on), enables and disables
the Autohold function that automatically engages the EPB electric parking brake when the ignition key is
turned to 0 (Key-off).
CAUTION
When the Autohold function is deactivated, when parking the vehicle, always remember to manually engage
the electric parking brake with the relative lever before switching off the engine.
On vehicles with mechanical gearbox, the Autohold function is not available, therefore before turning off the
engine the EPB electric parking brake must be engaged by means of the specific lever ( A).
Replacing the parking brake control panel
Located on the lower left hand dashboard trim panel.
Disconnect the battery (
Remove the lower left hand dashboard trim panel (
Refit the lower left hand dashboard trim (
Connect the battery (
DCT gearbox control buttons
Located at the front of the control panel on the centre console. FROM Assembly No. 94156 the AUTO
button (C) is located on the driver side.
F2.01).
E4.02).
F2.01).
E4.02).
Take particular care not to damage the
structure, the plastic fasteners and the
leather trim
Undo the three screws indicated fastening the
control panel (A) to the relevant mounting
bracket.
Remove the control panel (A) from the lower left
hand dashboard trim panel and replace.
Fit the new panel (A) on the lower left trim of the
dashboard.
Hand tighten the three screws indicated
fastening the control panel (A) to the relative
mounting bracket.
Advertisement
