Advertisement
Connect the battery (
If the luggage compartment lid does not close correctly, proceed as follows.
F2.01).
Mark the position of the luggage compartment lid
striker (B) relative to the bodyshell.
Disconnect the connector (1).
Undo the two screws indicated fastening the
luggage compartment lid striker plate (B).
Remove the luggage compartment lid striker
plate (B) from the relative seat and replace.
Fit the new luggage compartment lid striker (B)
in the respective seat, aligning the reference
marks made previously.
Tighten the two screws indicated and connect
the connector (1).
If necessary, move the RHT electrically into the
Coupé configuration.
Insert the ignition key in the driver side door lock;
turn the key counterclockwise and hold in this
position to start the Coupé to Spider RHT roof
cycle.
When the cycle has almost ended - specifically,
when the luggage compartment lid is
approximately 50 ± 10 mm from completely
closed - return the key to the vertical position,
interrupting the RHT roof cycle.
Wait 10 seconds, then turn the key
counterclockwise again to complete the
luggage compartment lid closing cycle.
While the aforementioned operation is in
progress, check that the luggage
compartment lid closes correctly without
requiring manual assistance.
Turn the ignition key clockwise and hold in this
position to start the Spider to Coupé RHT roof
cycle.
When the cycle has almost ended - specifically,
when the luggage compartment lid is
approximately 50 ± 10 mm from completely
closed - return the key to the vertical position,
interrupting the RHT roof cycle.
Wait 10 seconds, then turn the key clockwise
again to complete the luggage compartment
lid closing cycle.
While the aforementioned operation is in
progress, check that the luggage
compartment lid closes correctly without
requiring manual assistance.
Advertisement
