Advertisement
Block the flap (H) in the open position, applying a
strip of adhesive tape (16).
Insert the front seat belt (A) through the front
seat belt guide (D).
Hand tighten the two screws indicated fastening
the lower part of the front seat belt guide (D).
Tighten the centre fastener screw (9) for the
upper lateral trim panel.
Tightening torque
Screw
Fit the front seat belt guide (D) into the relative
seat on the upper lateral trim panel.
Hand tighten the screw (8) fastening the front
seat belt guide (D).
Nm
Class
10 Nm
B
Advertisement
