Advertisement
Bleed the RHT hydraulic system fluid (
Refit the Front Roof shell (
E6.12).
E6.04).
Release the clip (1).
Remove the pin (2).
Detach and remove the clip (3).
Remove the cylinder (A).
Before disconnecting the pipes, check that
the hydraulic system is not pressurised.
After the RHT roof open/close button is
released, the hydraulic system remains
pressurised for up to 5 minutes.
Disconnect the pipes (4) releasing the relevant
clips.
Replace the cylinder (A).
Every time the hydraulic cylinder pipes are
detached and refitted the relevant seals
and clip must be replaced.
Take particular care not to damage the pipe
seals and clips, since this could cause oil
leaks.
Connect the pipes (4) fitting the relevant clips.
Fit the gasket correctly on the cylinder then
push the pipe union gently into its relative
seat until it snaps audibly into place.
Position the new cylinder (A).
The incorrect positioning of the cylinder
fastener clips could cause the
detachment and consequent damaging of
the cylinder.
Check always the correct positioning of the
cylinder fastener clips.
Fit and attach the clip (3).
Install the pin (2).
Fasten the clip (1).
CAUTION
Danger of accident! At least two operators are
required to manually move the components of
the RHT roof, working slowly and in a
coordinated fashion.
Hold the Rear Roof shell and remove the rod
(AV
8178) previously positioned.
Move the Rear Roof shell by hand toward the
front of the vehicle until it is positioned over
the Front Roof shell.
Advertisement
